Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
^
Take a sharp awl and put a hole into emblem on the point shown.
Tip:
Apply gentle pressure on the awl while using a circular motion to pierce through emblem.
Once through surface:
^
Tilt awl at a 45 degrees angle.
^
Pry back till emblem comes off.
EMBLEM INSTALLATION
Attach new emblem Part No: 3B0 837 891 09Z, with a small drop of 3M quick fix adhesive Part No: 08155.
Tip:
Fold over a piece of tape, sticky side out and place on logo side of emblem. This helps to line up emblem correctly on the key.