Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
Secure the shift rod as follows:
-
Press down the selector shaft - direction of arrow 1 -.
-
While pressing down the selector shaft, rotate the locking pin - A - upward in - direction of arrow 3 - and simultaneously press it in the -
direction of arrow 2 - until it engages in the selector shaft.
-
Remove the shift boot, knob and, if present, the noise insulation. Refer to one of the following:
Eos, GTI through 2009, Golf/GTI from 2010, refer to => [ Shift Knob, Boot and Noise Insulation ] See: Service and Repair/Removal and
Replacement/02Q Transmission/Shift Knob, Boot and Noise Insulation.
Passat, Passat CC and CC, refer to => [ Shift Knob, Boot and Noise Insulation ] See: Service and Repair/Removal and Replacement/02Q
Transmission/Shift Knob, Boot and Noise Insulation.
Set the shift lever as follows:
-
Move the shift lever to the neutral position.
-
Guide the (T10027 A) through the hole - A - and into the hole - B -.