Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Brakes and Traction Control > Antilock Brakes / Traction Control Systems > Hydraulic Control Assembly - Antilock Brakes > Component Information > Service and Repair > ABS/ASR/Mark 70 Control Module and Hydraulic Unit > Page 3896

Page 4
background image

Note:
^

A new control module may be installed a max. of two times to a used hydraulic unit, to ensure that the elastic gasket seals sufficiently.

^

A control module which was once in driving operation must not be installed a second time.

Installing

Note:
^

Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.

^

If the sealing plugs are removed too early, brake fluid can escape. If this occurs, unit may not be sufficiently filled or adequately bled.

^

Installation is performed in the reverse order of removal.

^

Remove brake pedal loading device V.A.G. 1869/2.

^

Bleed brake system.

^

Enter radio code.

^

Code the ABS control module J104 with the in "Guided Fault Finding".

A steering angle sensor G85, transverse acceleration sensor G200 and brake pressure sensor 1 G201 basic setting must be done.

Brakes and Traction Control > Antilock Brakes / Traction Control Systems > Hydraulic Control Assembly - Antilock Brakes > Component Information > Service and Repair > ABS/ASR/Mark 70 Control Module and Hydraulic Unit > Page 3896

[PREV PAGE] [NEXT PAGE]