Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Brakes and Traction Control > Disc Brake System > Brake Caliper > Component Information > Service and Repair > Removal and Replacement > Page 3985

Page 9
background image

‹› With wear indicator.

‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster.

‹› Wear limit: 2 mm without backing plate.

‹› Must always be replaced together on both sides of axle.

‹› Removing and installing, refer to => [ Brake Pads ] See: Brake Pad/Service and Repair. 

5

Retaining spring

‹› Insert in both holes of brake caliper.

6

Brake carrier

‹› Bolt to wheel bearing housing.

7

Brake caliper

‹› Do not remove brake hose when replacing brake pad.

‹› Removing and installing, refer to => [ Brake Caliper ] See: Brake Caliper. 

‹› Disassembly, refer to => [ Brake Caliper Assembly Overview ] See: Brake Caliper Assembly Overview. 

8

Guide pins, 30 Nm

9

Cap

‹› Remove

10

Brake hose with banjo fitting and union bolt, 35 Nm

11

Guide pins, 30 Nm

12

Cap

‹› Remove

13

Bolt

14

Bracket

15

Ribbed bolt, 190 Nm

‹› Clean if reusing.

16

Wheel bearing housing

‹› With bolted brake carrier.

17

Wheel speed sensor

‹› Before inserting sensor, clean inner surface of bore hole and coat with hot bolt paste (G 052 112 A3).

18

Bolt, 8 Nm

19

Wheel bearing/hub unit

‹› The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing.

20

Cover plate

FNR-G

Brakes and Traction Control > Disc Brake System > Brake Caliper > Component Information > Service and Repair > Removal and Replacement > Page 3985

[PREV PAGE] [NEXT PAGE]