Eos (1F7) V6-3.2L (BUB) (2008)
/v6-3.2l_(bub)/Page-1172005.png)
-
Loosen both guide pins - arrows - and remove them from the brake caliper.
-
Remove the brake caliper and secure it with wire so that the weight of the brake caliper does not burden or damage the brake hose.
-
Remove the brake pads from the brake caliper.
Cleaning
CAUTION!
Do not use compressed air to blow on the brake system components, the dust produced is harmful to health!
-
Thoroughly clean the contact surfaces for the brake pads at the brake carrier, removing any corrosion.
-
Clean the brake caliper.
Use only appropriate solvents for cleaning brake caliper.
Installing
Before pressing the piston into the cylinder bore, some brake fluid must be extracted from the brake fluid reservoir. Otherwise, especially if
the reservoir has been topped off, fluid will overflow and cause damage.
-
Press the piston into the bore using the piston resetting tool (T 10145).
