Eos (1F7) V6-3.2L (BUB) (2008)
Carefully apply parking brake.
If vibration IS observed:
Clean all front and rear brake discs.
If vibration IS NOT observed:
Clean only front discs.
Remove wheels, disassemble brake calipers and remove brake disc. See appropriate Repair Manual for vehicle you are servicing.
Paint mark or scribe brake discs for reinstallation (Left/Right).
Paint mark brake pads for reinstallation (Left/Right, Inner/Outer).
Inspect all brake components for damage from outside influences.
Using micrometer, measure brake disc thickness. See appropriate Repair Manual in ElsaWeb for minimum brake disc thickness.
Brake Disc Surface Cleaning
Remove remaining corrosion protection coating as follows:
Sand brake disc surfaces until clean metal is visible using 40-grit sanding disc in a clockwise direction using leading edge of sanding disc (1-2 minute
Replace sanding disc prior to moving to next brake disc surface.
To achieve a crosshatch pattern:
Repeat sanding process using 80-grit sanding disc in a clockwise direction using trailing edge of sanding disc.