Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Brakes and Traction Control > Hydraulic System, Brakes > Brake Caliper > Component Information > Service and Repair > Removal and Replacement > Page 4103
Brake Caliper Assembly Overview
‹› After replacing the brake pads, press the brake pedal firmly several times with the vehicle stationary so that the brake pads are properly seated in
their normal operating position.
‹› Use the brake charger/bleeder unit (VAS 5234) or extraction device (VAG 1869/4) to extract brake fluid from brake fluid reservoir.
‹› Before removing the brake caliper or disconnecting the brake hose, the brake pedal actuator (VAG 1869/2) must be inserted (this dissipates
I - Front Wheel Drive (FWD) overview
II - All Wheel Drive (AWD) differences
Wheel speed sensor
‹› Before inserting sensor, clean inner surface of bore and coat with hot bolt paste (G 052 112 A3).
Bolt, 8 Nm
Bolt, 90 Nm + 90°
‹› Always replace after removal.
Wheel bearing housing
Hex head bolt, 9 Nm/Torx bolt12 Nm
|[PREV PAGE] [NEXT PAGE]|