Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Brakes and Traction Control > Hydraulic System, Brakes > Brake Caliper > Component Information > Service and Repair > Removal and Replacement > Page 4104
‹› Hex head bolt M6 x 10 changed from Torx bolt M6 x 12.
‹› Replace the hex head bolt with a hex head bolt and the Torx bolt with a Torx bolt.
Wheel bearing/hub unit
‹› 15 inches: 260 mm diameter, 16 inches: 286 mm diameter and 17 inches: 310 mm diameter.
‹› Thickness: 15 and 16 inches: 12 mm, 17 inches: 22 mm.
‹› Wear limit: 15 and 16 inches: 10 mm, 17 inches: 20 mm.
‹› Always replace pads on both sides of axle if worn.
‹› Remove brake caliper before removing.
Phillips head screw, 4 Nm
‹› Only on FWD.
‹› Thickness: 11 mm without backing plate.
‹› Wear limit: 2 mm without backing plate.
‹› Must always be replaced together on both sides of axle.
‹› Removing and installing, refer to => [ Brake Pads ] See: Disc Brake System/Brake Pad/Service and Repair.
Brake carrier with different guide pins and protective cap
‹› Supplied as pre-assembled replacement part with sufficient grease on guide pins.
‹› If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.
‹› Assembly guide, refer to => [ Assembly Guide, Brake Carrier CII 41 15 Inch
from 08.04 ]
‹› Always replace when pads are replaced.
‹› Do not remove brake hose when replacing brake pad.
‹› Removing and installing, refer to => [ Brake Caliper ] See: Brake Caliper.
‹› Disassembly, refer to => [ Brake Caliper Assembly Overview ] See: Brake Caliper Assembly Overview.
‹› After servicing or replacing, parking brake cable must be adjusted first.
‹› Adjusting parking brake, refer to => [ Parking Brake, Adjusting ] See: Parking Brake System/Adjustments.
Brake line, 14 Nm
Hex bolt, self locking, 35 Nm
|[PREV PAGE] [NEXT PAGE]|