Eos (1F7) V6-3.2L (BUB) (2008)
-
Tighten the M8 bolts - item 8 -=> [ Bolt ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and Repair to 23 Nm and tighten the M6
stud bolt - item 2 -=> [ Stud Bolt ] See: Cylinder Block Assembly/Balance Shaft Chain/Service and Repair to 8 Nm.
-
Install the chain tensioner for the camshaft timing chain and tighten it to 40 Nm.
-
Install the cylinder head cover. Refer to => [ Cylinder Head Cover ] See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder
Head Cover.
-
Install the intake manifold. Refer to => [ Intake Manifold ] See: Intake Manifold/Service and Repair/Intake Manifold.
The rest of the installation is basically a reverse of the removal sequence.