Eos (1F7) V6-3.2L (BUB) (2008)
-
Before installing, check the control housing strainer for contamination. Refer to => [ Control Housing, Checking
Strainer for Contaminants ] See: Service and Repair.
-
Before installing the control housing, lubricate the surfaces in the control housing contacting the camshaft seals.
-
Lubricate the camshaft seals and slowly push the control housing over the camshaft seals.
-
Install the control housing bolts - arrows - using locking adhesive (D 000 600 A2). Tightening specification: 8 Nm.
-
Install the camshaft adjustors with timing chain. Refer to => [ Camshaft Adjuster with Camshaft Timing Chain, Installing ] See: Variable Valve
Timing Actuator/Service and Repair/Camshaft Adjuster With Camshaft Timing Chain, Installing.
-
Clean the sealing surfaces on the cover and on the cylinder head.
-
Lubricate the oil passage seal O-ring - 1 - and insert it in the cover.