Eos (1F7) V6-3.2L (BUB) (2008)
Drive Belt: Service and Repair
Ribbed Belt Pulley With Freewheel, Valeo
Ribbed Belt Pulley with Freewheel, Valeo
Special tools, testers and auxiliary items required
‹› Multi-point adapter (VAS 3400)
‹› Torque Wrench (V.A.G 1332)
‹› TORX Screwdriver Insert (V.A.G 1603/1)
Removing:
-
Remove generator, refer to => [ Generator ] See: Starting and Charging/Charging System/Alternator/Description and Operation.
-
Tighten the generator in a vise at the mounting points.
-
Remove the cap from the ribbed belt pulley with freewheel.
-
Insert (VAS 3400) into ribbed belt pulley with freewheel of generator using open end wrench 17 mm.
-
Insert (V.A.G 1603/1) into generator shaft.
-
Hold the generator shaft and loosen the ribbed belt pulley with freewheel by turning it to the left using an open-end wrench.
-
Hold the ribbed belt pulley with freewheel steady. Turn the generator input shaft until it is possible to remove the ribbed belt pulley with
freewheel.
Installing:
Install in reverse order of removal, noting the following:
-
Next, screw ribbed belt pulley with freewheel onto generator driveshaft by hand until it reaches stop.
(V.A.G 1332) must be rearranged for installing ribbed belt pulley with freewheel as follows: