Eos (1F7) V6-3.2L (BUB) (2008)
6
Cap
‹› For the change over roller for the intake manifold change over
7
Seal
‹› Replace
8
Bolt
‹› 20 Nm
9
Low Pressure Connection
‹› For the brake booster.
10
Low Pressure Connection
‹› To the exhaust flap valve 1.
11
Low Pressure Connection
‹› To the vacuum reservoir.
12
Intake Manifold Support
13
Low Pressure Connection
‹› For the Evaporative Emission (EVAP) canister purge regulator valve (N80).
14
Vacuum Hose for Leak Detection Pump (LDP) (V144 )
15
Non Return Valve
‹› Black connection faces toward the T piece.
16
from Exhaust Flap Valve 1 (N321)
‹› Refer to => [ Vacuum Control Unit,
Individual Components ] See: Exhaust System/Muffler/Service and Repair/Muffler and Mounts Overview.
17
Throttle Valve Control Module (J338)
‹› With the throttle drive (for Electronic Power Control (EPC)) (G186), throttle drive angle sensor 1 (for EPC) (G187) and throttle drive angle
sensor 2 (for EPC) (G188).
‹› When replacing, adapt the Engine Control Module (ECM) to the throttle valve control module. Refer to "Guided Functions" in the vehicle
diagnostic tester.
18
Bracket
19
Bolt
‹› 10 Nm
20
Vacuum Actuator
‹› For the variable intake manifold.
‹› Checking vacuum actuator for intake manifold flaps, refer to => [ Intake Manifold Flap Vacuum Actuator, Checking ] See: Powertrain
Management/Fuel Delivery and Air Induction/Relays and Modules - Fuel Delivery and Air Induction/Variable Induction Control
Module/Testing and Inspection.
21
to Intake Manifold Tuning (IMT) Valve (N156)