Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Service and Repair > Crankshaft Seal, Transmission Side > Page 2103

Page 2
background image

-

Apply a bead of sealant (D 176 501 A1) approximately 2 to 3 mm as shown - arrows - on the clean sealing flange sealing surface.

‹› Cover the seal with a clean cloth before applying the sealant bead.

‹› The sealant bead must not be thicker than 2 to 3 mm or the excess sealant could get into the oil pan and clog the oil intake pipe strainer.

‹› Note the expiration date of the sealant.

‹› The sealing flange must be installed within 5 minutes after application of the sealant.

-

Install the (T10215/1) - 1 - onto the crankshaft - 3 -.

-

Slide the sealing flange with seal - 2 - carefully over the (T10215/1).

-

Fasten sealing flange to cylinder block.

-

Install the oil pan. Refer to => [ Oil Pan ] See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.

-

Install the vibration damper. Refer to => [ Vibration Damper ] See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and
Repair.

-

Install the ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Ribbed Belt.

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Service and Repair > Crankshaft Seal, Transmission Side > Page 2103

[PREV PAGE] [NEXT PAGE]