Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Engine, Cooling and Exhaust > Engine > Timing Components > Timing Chain > Component Information > Service and Repair > Camshaft Adjuster With Camshaft Timing Chain, Installing > Page 2169

Page 8
background image

-

Install the (T10068 A) into both camshaft grooves. If necessary, slightly rotate the camshaft back and forth using an open end wrench.

The camshaft adjusters can be attached to the camshafts -  arrows - in only one position. This is due to the alignment pin.

‹› The camshaft adjusters are locked in their rest position. Therefore the sensor wheels cannot be rotated when adjusting the valve timing. If the

locking mechanism in its rest position is not engaged (locked) turn the adjuster in both directions by hand until it locks. If that is not possible,
replaced the camshaft adjuster.

-

Ensure the camshaft timing chain rests against the guide rail - 1 - tautly and does not hang through.

Engine, Cooling and Exhaust > Engine > Timing Components > Timing Chain > Component Information > Service and Repair > Camshaft Adjuster With Camshaft Timing Chain, Installing > Page 2169

[PREV PAGE] [NEXT PAGE]