Eos (1F7) V6-3.2L (BUB) (2008)
‹› After rotating the crankshaft, the copper color chained links no longer align with the adjuster marks.
-
Apply sealant (D 176 501 A1) onto the clean sealing surfaces of the sealing flange as shown.
‹› Note the alignment pins in the cylinder block.
-
Install the sealing flange immediately.
-
To do this, install all the bolts by hand and tighten them to 10 Nm.
-
Install the sealing flange seal. Refer to => [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main Bearing Seal/Service
and Repair/Crankshaft Seal, Transmission Side.
-
Install the oil pan. Refer to => [ Oil Pan ] See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.
If replacing the seals in the camshaft front cover, refer to => [ Camshaft Front Cover
Seal, Installing ] See: Balance Shaft Chain/Service and Repair.
-
Clean the sealing surfaces on the cover and on the cylinder head.