![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Maintenance > Tune-up and Engine Performance Checks > Fuel Pressure > System Information > System Diagnosis > Fuel Pump Electrical, Testing > Page 1359![]() After repair work, the following work steps must be performed in the following sequence: 1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 03 - Read DTC 2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09 [ (BPY) (BUB) ]/Diagnostic Mode 04 - 3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes. End of diagnosis Maintenance > Tune-up and Engine Performance Checks > Fuel Pressure > System Information > System Diagnosis > Fuel Pump Electrical, Testing > Page 1359 | ||
[PREV PAGE] [NEXT PAGE] |