Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5020

Page 6
background image

-

Place new crimp contact into mount on crimp pliers.

-

Insert the stripped wire end with positioned single wire seal into crimp contact until it makes contact on wire stop.

-

Crimp the contact, wire and single wire seal by closing crimp pliers completely.

-

Open crimp pliers again and remove the finished crimped-on contact.

A correctly performed crimp is distinguished by a clean compression of wire and single wire seal in the contact and has an impression on the rear side
which identifies that the crimp was performed by a professional using the correct tool.

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5020

[PREV PAGE] [NEXT PAGE]