Eos (1F7) V6-3.2L (BUB) (2008)
Headlamp Alignment Control Module: Service and Repair
High-Intensity Gas Discharge Lamp Control Module
High-Intensity Gas Discharge Lamp Control Module
NOTE:
-
Left High-intensity Gas Discharge Lamp Control Module J343 and Right High-intensity Gas Discharge Lamp Control Module J344 is not capable
of On Board Diagnostic (OBD).
-
Illustrations depict replacement of High-intensity Gas Discharge Lamp Control Module at right headlamp.
-
Replacement of Left High-intensity Gas Discharge Lamp Control Module J343 and of Right High-intensity Gas Discharge Lamp Control Module
J344 is performed analogously.
-
Check headlamp function.
-
Check and adjust headlamp aim if necessary
Removing
NOTE: Observe safety notes
-
Remove headlamp.
-
Remove mounting bolts - 3 - and remove gas discharge lamp control module - 2 - from headlamp connector position - 1 -.
Installing
Install in reverse order of removal, noting the following:
NOTE: Make sure seals have proper seating when installing High-intensity Gas Discharge Lamp Control Module. Water intrusion will damage
headlamp.