Eos (1F7) V6-3.2L (BUB) (2008)
Seat Belt: Service and Repair
Rear Seat Belts
Rear Seat Belts
‹› Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the
same manner.
Removing
-
Remove seat bench. Refer to => [ Bench Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seats.
-
Remove headrest cover. Refer to => [ Headrest Cover ] See: Body and Frame/Seats/Head Rest/Service and Repair.
-
Remove backrest. Refer to => [ Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seats
-
Remove side trim. Refer to => [ Side Trim ] See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Side Trim
-
Remove rollover protection trim. Refer to => [ Rollover Protection Trim ] See: Body and Frame/Roll Bar/Service and Repair/Removal and
Replacement/Rollover Protection Trim
-
Remove rollover protection trim support piece. Refer to => [ Rollover Protection Support Trim ] See: Body and Frame/Roll Bar/Service and
Repair/Removal and Replacement/Rollover Protection Support Trim
-
Remove rear seat belt anchors. Refer to => [ Rear Seat Belt Anchors ] See: Rear Seat Belt Anchors
-
Press belt guide - 1 - in upper area out of catch - arrow A -.
-
Press belt guide down diagonally out of catch - arrow B -.
-
Remove bolt - 2 - (40 Nm).
-
Remove belt inertia reel - 3 - from mount in body.
-
Thread seat belt with belt guide - 1 -, safety belt latching tongue and belt anchor through belt relay - 4 -.