Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Restraint Systems > Sensors and Switches - Restraint Systems > Impact Sensor > Component Information > Locations > Page 6579
Impact Sensor: Service and Repair
Front Door Crash Sensors
‹› Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the
Disconnect vehicle battery.
Remove corresponding door trim:
‹› Driver's side, refer to => [ Driver Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Driver Door Trim
‹› Passenger's side, refer to => [ Passenger Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service
and Repair/Passenger Door Trim
Separate wiring harness - 1 - from crash sensor - 3 -.
Remove the two bolts - 2 - (2.5 Nm).
Perform the steps used for removal in reverse order.
Switch on ignition.
Connect vehicle battery.
|[PREV PAGE] [NEXT PAGE]|