Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Restraint Systems > Sensors and Switches - Restraint Systems > Seat Occupant Sensor > Component Information > Service and Repair > Procedures > Page 6608

Page 16
background image

Passive Occupant Detection System Repair Kit, Power Seats, Installing

Passive Occupant Detection System Repair Kit, Power Seats, Installing

‹› When installing, there must be no wiring harness of seat heater between upholstery and mat for seat occupied recognition.

‹› Pressure hose must be routed without kinking.

‹› Stickers with notes on harness connectors must not be damaged.

‹› After being connected to the vehicle electrical system, verify that the replaced components can move easily by moving the seat.

After replacing seat occupied recognition, basic setting of seat occupied recognition must be performed using diagnostic tester containing "Guided
Fault Finding".

CAUTION!
Basic setting must be performed when seat is not occupied.

Installation is reverse of removal, noting the following: 

-

Secure insertion profile - 2 - with double-sided tape - 3 - on seat frame - 1 - as shown.

Restraint Systems > Sensors and Switches - Restraint Systems > Seat Occupant Sensor > Component Information > Service and Repair > Procedures > Page 6608

[PREV PAGE] [NEXT PAGE]