Do Not Sell My Personal Information
volkswagen Workshop Repair Guides

Volkswagen Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 2
background image

-

Remove screw - 2 - and remove sensor - 1 - from striker pin - 4 -.

When replacing sensor, disconnect wire - 3 - approximately 130 mm from sensor, between cable brackets. After repairing wiring harness, wiring must
be secured in harness again.

Tightening specification for screw - 2 -: 3 Nm.

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Position Sensor / Switch > Component Information > Service and Repair > Roof Pillar Front Position Sensors > Page 682

< PREV PAGE NEXT PAGE >