Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Position Sensor / Switch > Component Information > Service and Repair > Roof Pillar Front Position Sensors > Page 684
Remove screw - 2 - and remove sensor - 1 - from main hinge - 4 -.
When replacing sensor, disconnect wire - 3 - approximately 220 mm from sensor, behind corner. After repairing wiring harness, wiring must be
Tighten screws - 2 -: 3 Nm.
|[PREV PAGE] [NEXT PAGE]|