Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Sensor > Component Information > Locations > Page 1117

Page 1
background image

Throttle Position Sensor: Testing and Inspection

Throttle Position Sensor G79 and Accelerator Pedal Position Sensor 2 G185, Checking

Special tools, testers and auxiliary items required

‹› Multimeter.

‹› Wiring diagram

Test requirement

‹› The Engine Control Module (ECM) ( J623) fuses OK.

‹› Battery voltage at least 12.5 volts.

‹› All electrical consumers such as, lights and rear window defroster, switched off.

‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".

‹› A/C switched off.

‹› Ground (GND) connections between engine/transmission/chassis OK.

‹› Use only gold-plated terminals when servicing the electrical harness connector terminals in Throttle Position (TP) Sensor (G79 )/Accelerator

Pedal Position Sensor 2 (G185).

Test procedure

-

Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Preliminary Check

Start diagnosis

-

Remove the drivers side storage compartment.

-

Disconnect the Throttle Position (TP) Sensor ( G79)/Accelerator Pedal Position Sensor 2 (G185 ) 6-pin electrical harness connector - 2 -.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Sensor > Component Information > Locations > Page 1117

[PREV PAGE] [NEXT PAGE]