Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Sensor > Component Information > Locations > Page 1118

Page 2
background image

Checking voltage supply and wiring

-

Switch the ignition on.

-

Using a Multimeter, check the following wiring connections for voltage.

-

Switch the ignition off.

If the specification is not obtained:

If the manufacturers test box is being used. Perform the following step.

-

Install the Test Box 105 Pin (VAG1598/31).

If the manufacturers test box is not being used. Perform the following step.

-

Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module J623, Replacing ] See: Powertrain
Management/Computers and Control Systems/Engine Control Module/Service and Repair/Engine Control Module J623, Replacing.

-

Using a Multimeter, check the Throttle Position (TP) Sensor (G79)/Accelerator Pedal Position Sensor 2 (G185) electrical harness connector
terminals to the Engine Control Module (ECM) (J623) electrical connector T121 for an open circuit according to wiring diagram.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Sensor > Component Information > Locations > Page 1118

[PREV PAGE] [NEXT PAGE]