Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Sensors and Switches > Sensors and Switches - Restraint Systems > Seat Occupant Sensor > Component Information > Service and Repair > Procedures > Page 1164

Page 2
background image

Passive Occupant Detection System Components, Manual Seats

CAUTION!
Observe safety precautions when working on seat occupied recognition. Refer to => [ Passive Occupant Detection System Safety
Precautions ] See: Service Precautions/Passive Occupant Detection System Safety Precautions.

‹› Seat cushion, mat for seat occupied recognition, control module and pressure sensor must only be replaced together. Components are

complementary and must not be separated!

‹› Only disconnect wiring harnesses mentioned in the following description! 

-

Mount the fixture for seat repair (VAS 6136 ) on the engine and transmission holder (VAS 6095 ).

-

Remove front seat. Refer to => [ Front Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seats. 

-

Attach the seat to the fixture for seat repair ( VAS 6136).

-

Remove the front safety belt latch. Refer to => [ Front Seat Belt Latches ] See: Restraint Systems/Seat Belt Systems/Service and Repair/Front Seat
Belt Latches

-

Remove front right seat trim. Refer to => [ Right Seat Trim ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front
Seats

-

Remove front left seat trim. Refer to => [ Left Seat Trim ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seats

-

Remove bracket and front seat operating lever. Refer to => [ Front Seat Support and Operating Lever ] See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Front Seats.

-

Remove seat drawer mount. Refer to => [ Seat Drawer Mount ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front
Seats

-

If present, remove connector - 1 - from Front Passenger's Heated Seat Control Module (J132).

-

If equipped, remove retaining clip - 2 -.

-

Remove retaining clips - 3 -.

-

If present, disconnect connector - 4 - and remove connector from seat frame.

-

Disconnect side airbag connector - 5 - and remove connector from seat frame.

-

Remove line clip - 6 - and disconnect backrest wiring harness from seat frame.

Sensors and Switches > Sensors and Switches - Restraint Systems > Seat Occupant Sensor > Component Information > Service and Repair > Procedures > Page 1164

[PREV PAGE] [NEXT PAGE]