Eos (1F7) V6-3.2L (BUB) (2008)
Alternator Pulley: Service and Repair
Ribbed Belt Pulley With Freewheel, Valeo
Ribbed Belt Pulley With Freewheel, Valeo
Special tools, testers and auxiliary items required
-
Multi-point adapter VAS 3400
-
Torque wrench V.A.G 1332
-
TORX screwdriver insert V.A.G 1603/1
Removing
-
Remove generator.
-
Tighten the generator in a vise at the attachment points.
-
Remove protective cap from ribbed belt pulley with freewheel.
-
Insert multipoint adapter VAS 3400 into ribbed belt pulley with freewheel of generator using ring wrench 17 mm.
-
Insert TORX screwdriver insert V.A.G 1603/1 into generator shaft.
-
Loosen the threaded connection by rotating clockwise, while counter holding with the box-end wrench.
-
Hold ribbed belt pulley with freewheel in place by hand and turn at generator drive shaft until ribbed belt pulley with freewheel can be removed.
Installing
Install in reverse order of removal, noting the following:
-
Next, screw ribbed belt pulley with freewheel onto generator drive shaft by hand until it reaches stop.
Torque wrench V.A.G 1332 must be rearranged for installing ribbed belt pulley with freewheel as follows:
-
Disengage socket - 1 - and pull it off handle part - 2 -.
-
Turn around handle part - 2 - of torque wrench 180 degrees and insert socket again.
-
Set turning direction of torque wrench to left at socket.