Eos (1F7) V6-3.2L (BUB) (2008)
‹› Note the safety precautions. Refer to => [ Safety Precautions for Run-Flat Tires, Removing and Mounting ] See: Service
Precautions/Safety Precautions For Run-Flat Tires, Removing and Mounting.
Turn wheel on tire mounting device so that tire valve/tire pressure sensor - 2 - stands in front of mounting head - 1 -.
Mounting head - 1 - must not be located in area - a - of tire valve/tire pressure sensor, otherwise the mounting head will damage the tire pressure
Position mounting head - 1 - in vicinity of tire valve/tire pressure sensor so that tire iron can be put on approximately 30° next to tire valve/tire
pressure sensor - 2 -.
Install press holders - 3 - on disc wheel opposite the mounting head - 1 -.
Now pry tire bead over mounting finger on mounting head using tire iron and remove tire iron again.
Let the tire dismounting/mounting machine run clockwise until upper bead lies completely above the rim flange.