![]() |
Volkswagen Workshop Manuals | |
Eos (1F7) V6-3.2L (BUB) (2008)Steering and Suspension > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures![]() Wheel Bearing: Procedures Wheel Bearing, Lifting to Curb Weight Position Special tools, testers and auxiliary items required ‹› Engine/transmission jack (V.A.G 1383 A) ‹› Tensioning strap (T10038) ‹› Mount (T10149) ‹› All bolts at suspension parts with bonded rubber bushings must always be tightened in curb weight position (unloaded condition). Bonded rubber bushings can only be turned to a limited extent. Parts with bonded rubber bushings must therefore be brought into a position that corresponds to the position in driving mode before being tightened Otherwise, the bonded rubber bushing will be stressed resulting in a shortened service life. By raising appropriate suspension using (V.A.G 1383 A) and (T10149), this position can be simulated on the hoist. ‹› Before lifting the axle on one side, the vehicle must be secured on both sides to the lift arms of the lift using (T10038). CAUTION! - Turn wheel hub far enough until one of the holes for wheel bolts is on top. - Install (T10149) with wheel bolt on wheel hub. Tightening of the respective bolts/nuts must then only occur after dimension - a - between the wheel hub center and the lower edge of wheel Dimension - a - is dependent on standing height of installed suspension: Steering and Suspension > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures | ||
[PREV PAGE] [NEXT PAGE] |