Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Eos (1F7) V6-3.2L (BUB) (2008)

Steering and Suspension > Wheels and Tires > Wheels > Component Information > Service and Repair > Wheel Mounting, Protecting against Corrosion > Page 5826

Page 6
background image

In this case, radial run-out can be reduced by matched mounting of the tire. Refer to => [ Matched Mounting ] See: Tires/Service and Repair/Matched
Mounting.

Disc Wheel, Checking Radial and Lateral Run Out

Disc Wheel, Checking Radial and Lateral Run Out

-

Mount the disc wheel on the wheel balancer.

-

Use the centering system for wheel balancing machines (VAS 5271).

-

Load the tire dial gauge approximately 2 mm.

-

Slowly turn the disc wheel.

-

Note the smallest and the largest dial readings.

S

Lateral run-out

H Radial run-out

-

Compare determined value with specifications in the table.

‹› Peak values on the tire dial gauge due to small irregularities may be disregarded.

Specifications for Radial and Lateral Run-Out on Disc Wheel

‹› If the measured value exceeds the specified value, no acceptable smooth running can be attained.

Steering and Suspension > Wheels and Tires > Wheels > Component Information > Service and Repair > Wheel Mounting, Protecting against Corrosion > Page 5826

[PREV PAGE] [NEXT PAGE]