Volkswagen Workshop Manuals
Eos (1F7) V6-3.2L (BUB) (2008)
Transmission and Drivetrain > Transmission Control Systems > Sensors and Switches - Transmission and Drivetrain > Sensors and Switches - M/T > Transmission Speed Sensor, M/T > Component Information > Locations > Page 3854
Transmission Speed Sensor: Service and Repair
Transmission Input Speed Sensor and Clutch Oil Temperature Sensor
Both sensors are combined into one component and can only be replaced together. They are coated with oil in the transmission near the multi-plate
Often, the sensor wire is pulled on. This damages it. If the wire was pulled on, the sensor must be replaced.
Remove the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Manual Transmission/Transaxle/Gearshift Actuating
Do not pull on the wire!
Remove the bolt and carefully pry out the sensor using a screwdriver or pliers.
Only install the old sensor, if it is certain that:
‹› The sensor functions properly.
‹› The wire was not pulled on during removal.
If this is not the case, you should install a new sensor.
Install the sensor lubricated with DSG oil.
Tighten the bolt to 10 Nm.
Install the Mechatronic unit. Refer to => [ Mechatronic Unit, Transmission Installed ] See: Manual Transmission/Transaxle/Gearshift Actuating
One special request:
|[PREV PAGE] [NEXT PAGE]|