Eurovan V6-2.8L (AXK) (2001)
-
3272 Resetting and removal tool
-
3409 Wedge
-
Bleeder container
Removal
-
Screw piston out of brake caliper housing by turning knurled wheel counter-clockwise.
NOTE:
^
Do not damage the protective seal when removing the piston.
^
Position special tool 3272 so that the collar (arrow) is in front of the piston.
^
If the piston is difficult to move, use a 13 mm open end wrench on the flats (arrow A) provided for this purpose.
^
The surfaces of the piston and the seal must only be cleaned with methylated spirits and then dried.
-
Remove seal using wedge 3409.
Installation
-
Thinly coat piston and seal with assembly lubricant G 052 150 A2 before installing.
-
Place protective seal with outer sealing lip on piston.