Eurovan V6-2.8L (AXK) (2001)
/Page-1199005.png)
11 - Eccentric bolt
^
Adjusting after-run
12 - Coupling link
^
For stabilizer 27 mm
^
Unbolt and bolt on at stabilizer go to Fig. 15
13 - Hex bolt
^
M14 x 1.5 x 175
14 - Rubber bearing
^
Only at coupling rod for stabilizer 23.5 mm
^
Removing and installing go to Fig. 16
15 - Coupling link
^
For stabilizer 23.5 mm
^
Push off of stabilizer go to Fig. 14
16 - Rubber bearing
^
Removing and installing go to Fig. 17 and 18
17 - Socket
^
Removing and installing go to Fig. 17 and 18
18 - Lower ball joint
19 - Lower control arm
^
Hold in installation position when tightening bolts.
20 - Self locking hex nut
^
60 Nm +90° (1/4 turn)
^
Always replace after disassembly
21 - Socket head bolt M12 x 1.5 x 30
^
90 Nm + 90° (1/4 turn)
^
Always replace after disassembly
^
Use socket head wrench 14 (e.g. Hazet 990)
22 - Hex-nut, tighten to 160 Nm
23 - Front bearing for bottom control arm
^
Remove rubber collar for pressing out go to Fig. 4, and bend up metal collar go to Fig. 5
^
Pressing out go to Fig. 6
^
Pressing in Fig. 7 and go to Fig. 8
24 - Hex bolt
^
M 14 x 1.5 x 82
25 - Self locking hex nut
^
60 Nm + 90° (1/4 turn)
^
Always replace after disassembly
26 - Eccentric washer
27 - Wheel bearing housing
28 - Hex-nut, tighten to 100 Nm
^
Always replace after disassembly
29 - Front bearing for upper control arm
^
Pressing out go to Fig. 1
^
Pressing in Fig. 2
30 - Upper control arm
^
Can only be removed with the subframe removed
^
Hold in installation position when tightening bolts.
31 - Hex bolt
^
M 14 x 1.5 x 80
32 - Hex bolt
^
M 14 x 1.5 x 80
