Eurovan V6-2.8L (AXK) (2001)
/Page-1221002.png)
9 - Spacer tube
10 - Lower bearing ring
11 - Hex bolt, 100 Nm
12 - Cylinder bolt
^
80 Nm +90° (1/4 turn)
^
Always replace after disassembly
13 - Pendulum supports
^
Unbolt and bolt in, from Unit Support Removing and Installing.
14 - Hex bolt 200 Nm
^
Always replace after disassembly
15 - Unit support
16 - Clamp
17- Hex bolt, 55 Nm
18 - Weld nut
^
Repair if damaged
19 - Stabilizer bearing
20 - Stabilizer bar
23.5 mm
21 - Stabilizer bar
^
27 mm
22 - Rubber bearing
23 - Torsion - bar adjustment bolt.
24 - Torsion bar
^
marked in blue at right on facing side
^
marked in yellow at left on facing side
^
Must not be swapped
^
Check for paint damage, repair if necessary
25 - Nut for tensioning torsion bar
^
Always replace
^
Measure projecting end of thread before unbolting.
^
Do not loosen using an air wrench
26 - Hex bolt, 160 Nm
^
M14 x 1.5 x 30
27 - Hexnut, tighten to 130 Nm
28 - Hex bolt
^
M 14 x 1.5 x42
29 - Upper control arm
^
Can only be removed with the subframe removed
30 - Hex bolt, 100 Nm
^
M 12 x 1.5 x 32
31 - Hex bolt, 160 Nm
^
M 14 x 1.5 x40
Removal and Installation
Special Tools and Equipment
^
3079 counter holder
Removing
^
Relieve torsion bar, refer to Torsion Bar.
^
Remove lower bolt for shock absorber.
^
Unbolt mount for shock absorber from body.
