GLI L4-2.0L Turbo (CCTA) (2008)
^
Dual mass flywheel, removing and installing.
^
Only possible to install in one position - Bores are offset
8 -
Fitting pin
Sealing Flange, Transmission Side, Tightening Sequence and Tightening Specification
Special tools, testers and auxiliary items required
^
Torque wrench V.A.G 1331
Procedure
-
Tighten bolts in 2 stages in sequence - 1 to 8 - as follows:
-
Tighten bolts by hand.
-
Tighten bolts to 9 Nm.
Installing Intermediate Plate
-
Hook in intermediate plate at sealing flange and push it onto alignment sleeves - arrows -.