|
Removing and installing parts of fuel supply system
Rules for cleanliness
When working on the fuel supply/injection system, pay careful attention to the following "5 rules":
-
◆ Thoroughly clean all unions and the adjacent areas before disconnecting.
-
◆ Place parts that have been removed on a clean surface and cover. Do not use fluffy cloths!
-
◆ Carefully cover opened components or seal, if the repair cannot be carried out immediately.
-
◆ Only install clean components:
Only unpack replacement parts immediately prior to installation.
Do not use parts have been stored loose (e.g. in tool boxes etc.).
-
◆ When the system is open:
Do not work with compressed air if this can be avoided.
Do not move vehicle unless absolutely necessary.
|
