Repairing 2EE Carburettor: Upper Part | Golf Mk2 Power Unit
Carburettor upper part |
1 - | Float chamber breather change-over valve -N116- |
q | Vehicles with activated charcoal filter system only. |
q | Checking → Chapter |
2 - | Seal |
q | Renew. |
3 - | Breather pipe |
q | For float chamber. |
4 - | Flame protector screen |
q | Float chamber breather. |
5 - | Pipe for full-load enrichment |
q | Adjusting → Fig.. |
6 - | Bolt |
q | 5 Nm |
7 - | Dynamic float chamber breather cut-off valve -N141- |
q | Vehicles 08.88 ►. |
q | Checking → Chapter |
8 - | Air flap |
q | Checking air flap positioner -V63- and ease of movement → Chapter. |
9 - | Carburettor upper part |
q | Removing: Remove air flap positioner -V63- and throttle valve positioner potentiometer -G88- complete with bracket beforehand. |
q | With activated charcoal filter system: With float chamber breather change-over valve -N116-, checking → Chapter. |
10 - | Bracket |
q | For air flap positioner -V63- and throttle valve positioner potentiometer -G88-. |
11 - | Air flap positioner -V63- |
q | Checking actuation → Chapter. |
q | Checking final control diagnosis → Chapter. |
q | On installation, make sure that connecting rod (to air flap) and locking pin are correctly seated in recess. |
q | Do not connect to battery (+). |
12 - | Retaining ring |
q | For retaining air flap positioner -V63-; insert retaining lugs of ring into recesses on bracket and screw ring on. |
13 - | Locking wedge |
14 - | Pre-atomiser, stage II |
15 - | Plug |
q | To remove main nozzle, unscrew sealing plugs and swivel cover plate to side. |
16 - | Seal |
q | Renew. |
17 - | Float |
18 - | Float needle |
q | Before removing, attach to float. |
19 - | Float axis |
20 - | Main nozzle stage I |
q | → Fig. |
21 - | Idle fuel nozzle |
q | → Fig. |
22 - | Main nozzle stage II |
q | → Fig. |
23 - | Pre-atomiser, stage I |
24 - | Seal |
q | Do not interchange. |
q | Note installation position. |
q | Renew. |
25 - | Screen |
q | Extract with commercially available puller for locking caps (e.g. puller -Hazet 4518/1-). |