Golf Mk3
| Assembly overview - sliding/tilting roof with glass panel |
| 1 - | Glass panel for sunroof (single pane safety glass) |
| q | Removing glass panel for sliding/tilting sunroof → Chapter |
| q | Installing glass panel for sliding/tilting sunroof → Chapter |
| q | Adjusting glass panel for sliding/tilting sunroof → Chapter |
| 2 - | Panel seal |
| q | Adjusting panel seal → Chapter |
| q | Seal joint is in centre of right side section |
| q | Treat panel seal clamping channel with water as lubricant before fitting |
| 3 - | Trim frame |
| q | Removing → Chapter, Removing glass panel for sunroof |
| 4 - | Sliding headliner ► 08.94 |
| q | Removing and installing sliding headliner → Chapter |
| q | Up to chassis No. 1 HZN WO 34710, the electric drive must also be renewed when renewing the sliding headliner (8.25 turns when pushing on the glass panel) |
| 5 - | Sliding headliner 09.94 ► |
| q | Removing and installing sliding headliner → Chapter |
| 6 - | Carrier unit |
| q | Removing and installing carrier unit → Chapter |
| q | Carrier unit comprises of following parts: |
| t | U-frame (with guide channels) |
| t | Rear guides with cables |
| t | Front guides |
| q | If needed, guide channels must be greased with special grease -G 000 450 02- only, otherwise correct operation cannot be guaranteed. |
| 7 - | Crank for emergency operation |
| q | Clipped into electric drive |
| 8 - | Wind deflector |
| q | Open panel to rear and unscrew wind deflector |
| 9 - | Wind deflector bearing |
| q | Thread must point to rear at an angle |
| 10 - | Securing bolt for wind deflector |
| 11 - | Countersunk screws (microencapsulated) |
| q | Always use new countersunk screws |
| q | 3 Nm |
| 12 - | Electric drive |
| q | Checking electric drive (0 position) → Chapter |
| 13 - | Retaining hook |
| 14 - | Detent hook spring |
| 15 - | Torx bolt |
| q | Torx insert -T25- |
| q | 6 Nm |
| 16 - | Retainer |
| 17 - | Water drain hoses |
| q | Cleaning water drain hoses → Chapter |
