volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting sunroof glass panel height > < Removing glass panel for sliding/tilting sunroof

Golf Mk3

Installing glass panel for sliding/tilting sunroof
Installing glass panel for sliding/tilting sunroof
Glass panel must be installed in 0 position (glass panel closed).
–  Check parallel running and if necessary adjust → Chapter
   
–  Fit glass panel for sliding/tilting sunroof from above and screw on securing bolts -1- with clamping plates -2-. Ensure the centralising pins -3- on the back of the clamping plate is seated correctly. Specified torque: 6 Nm
  Note
After adjusting panel height, tighten securing screws (6 Nm).
–  Perform height adjustment → Chapter.
–  Check seating of the panel seal and if necessary adjust → Chapter.
–  Slide trim frame forwards and clip in.
–  Check that sliding/tilting roof functions correctly with no problems.
  V60-0488

Adjusting sunroof glass panel height > < Removing glass panel for sliding/tilting sunroof