Golf Mk3
| Removing and installing door insulation film |
| Removing and installing door insulation film ► 12.93 |
| Insulation films serve to seal the vehicle's interior against noise, water ingress and drafts. |
| Self-adhesive insulation films are supplied as spare parts. |
| The insulation film must always be adhered carefully and without creases. On replacement, the adhering surfaces must be cleaned and the new film must be adhered from bottom to top without creasing. |
| If film does not adhere sufficiently, use double-sided adhesive tape -AKL 434 019 25-. |
| Adhering surface: -hatched area- |
| Removing and installing door insulation film 01.94 ► |
| Insulation films serve to seal the vehicle's interior against noise, water ingress and drafts. |
| Noise insulation film can be pulled off and repositioned up to four times without applying additional adhesive, as long as the insulation film is undamaged. |
| Replacement insulation film was supplied ► 02.95 with self-adhesive properties. |
| Replacement insulation film from 03.95 ► is supplied without self-adhesive properties. |
| These replacement films are bonded with adhesive sealant -D 469 101 A3-. |
| Adhering surface: -hatched area- |
