| –
| Tape down the A pillar and the windscreen glass with fabric-reinforced tape. |
| –
| Remove residual adhesive with a tool (e.g. a firmer chisel). |
Note | Residual adhesive must be removed since an increase in the height of the water deflector strip can lead to wind noise. |
| –
| Damage to paint should be touched up with paint primer D 009 200 02. |
| –
| Clean the water deflector strips with cleaning solution D 009 401 04 and then prime them with paint primer D 009 200 02. |
Note | Allow 10 minutes drying time after both procedures, cleaning and priming. |
| –
| Coat the primed surface with 1K window adhesive DH 009 100 03 (approx. 1-2 mm in diameter). |
| –
| Fit the water deflector strips in place, press them in and secure them with fabric-reinforced tape. |
Note | Wait two hours before removing the tape strips. |
|
|
|
