-
‒ →
Pull 5-pin connector off control unit -J255-
-
‒ Connect cables from adapter set V.A.G 1594 A to chambers 4 and 5.
-
‒ Connect to 12 V supply. Direction of rotation can be changed by reversing polarity of voltage supply.
-
‒ Move temperature flap -2- with control motor -1- from heater end position -4- to fresh air end position -3-.
-
‒ Check whether the temperature flap lever -2- reaches the stop when at the end position. If necessary, adjust length of connecting rod -1- with temperature flap -2- on stop.
Checking:
By reversing polarity of 12V voltage, positioning motor must move to both end positions.
|