-
‒ Carry out electrical check, test step 22
.
Checking voltage supply
-
‒ Pull 3 pin connector off Hall sender (G40).
-
‒ →
Connect hand multimeter V.A.G 1526 to measure voltage using aux. cables from V.A.G 1594 to disconnected plug contacts 1 and 3.
-
‒ Switch on ignition.
Specification: At least 4.5 V
-
‒ Switch off ignition
If the specifications are attained:
-
‒ Renew distributor with Hall sender
, Item 17
.
If the specifications are not attained:
-
‒ Renew Motronic control unit (J220)
=> Page 24-8
, item 12
.
|