Servicing anti-theft alarm (ATA)
Removing and installing anti-theft alarm system control unit (J 284)
Removing:
-
‒ Remove drivers' side dash panel trim
-
‒ Pull 6 pin and 10 pin connectors off anti-theft alarm system control unit (J 284), located behind assembly carrier on left A pillar
Only for vehicles with cruise control system:
-
‒ Pull 12 pin connector off cruise control system control unit (J 213), located behind assembly carrier on left A pillar
Note:
On vehicles with cruise control system, the anti-theft alarm system control unit (J 284) and the cruise control system control unit (J 213) are secured to the same retaining plate.
|