volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Technical conditions for converting wheel and tyre combinations > < Legislative and technical conditions for converting wheel and tyre combinations
Legislative conditions for converting wheel and tyre combinations
Legislative conditions for converting wheel and tyre combinations
The manufacturer is issued with a general operating permit (GTA in accordance with § 20 StVZO (German road traffic and licensing regulations) and EU operating permit) for the overall vehicle with all parts for specific conversions.
Conversions of wheels and tyres can only be carried out under certain conditions. When doing this, the following points must be observed:
t  If the size of wheel and tyre, with an indication of the load index and the speed symbol, is included in the vehicle GTA and EU operating permit/type approval → Chapter, this wheel and tyre combination can be fitted on the vehicle without any problem.
It is not necessary for the wheel and tyre combination specified in the registration certificate part I (certificate of registration) to be fitted. All combinations approved in the vehicle GTA or EU operating permit/type approval → Chapter may be fitted to the vehicle.
t  For the conversions recommended by VOLKSWAGEN AG (see appendix to parts certificate) there are no general operating permits in accordance with § 22 StVZO (German road traffic and licensing regulations).
t  Unless the wheels and/or tyres are included in the relevant vehicle GTA or EU operating permit/type approval, the vehicle will no longer meet the requirements of the road traffic regulations if converted.
These versions are based on the conditions valid in the European Union and no guarantee can be provided for their completeness. In some cases there are different legislative requirements outside the European Union.
The table included in the appendix for parts certificate shows the VOLKSWAGEN AG recommended and TÜV NORD Mobilität GmbH & Co. KG tested wheel and tyre combinations on VW vehicles and also the conditions to be observed for fitting. The use of genuine disc-type wheels on a vehicle to which they have not been allocated is not permissible.
The list of possible conversions deals with combinations that meet the requirements of VOLKSWAGEN AG with regards to road handling and road safety. They are the result of practical trials and are therefore recommended by VOLKSWAGEN AG.
Refer also to the new vehicle registration documents that were issued from 01.10.2005 → Chapter.
   

Technical conditions for converting wheel and tyre combinations > < Legislative and technical conditions for converting wheel and tyre combinations