Golf Mk4
Assembly overview - bumper cover, Golf R32 |
Note
The removal and installation procedures may have to be modified slightly depending on variations in equipment. |
1 - | Bumper cover |
q | Material - PP/EPDM |
q | Removing → Chapter |
2 - | Bolt |
q | Qty. 7 |
q | 6.6 Nm |
3 - | Guide element |
q | To remove and install, pull out/push in bumper cover parallel to guide elements (left and right). |
4 - | Wheel housing liner |
5 - | Bolt |
q | Qty. 8 |
q | 1.5 Nm |
6 - | Bolt |
q | Qty. 2 |
q | 1.5 Nm |
7 - | Adapter |
q | With 2 speed nuts |
q | Before removing adapter, remove wheel housing liner |
q | Removing and installing → Chapter |
8 - | Speed nut |
q | Qty. 8 |
9 - | Cover for headlight washer system |
q | The cover is clipped into the washer jet of the headlight washer system |
10 - | Left air intake grille |
q | Clipped in bumper cover |
11 - | Centre air intake grille |
q | Attached in bumper cover by clips |
q | Assembly overview → Chapter |
q | Removal of air intake grille is only possible with bumper cover removed |
12 - | Right air intake grille |
q | Clipped in bumper cover |