Golf Mk4
| Assembly overview |
| 1 - | 100 Nm + 1/4 turn (90°) further |
| q | Renew |
| q | Use counterhold -T10069- to loosen and tighten → Chapter |
| q | Tighten using torque wrench -V.A.G 1601-. |
| 2 - | Vibration damper |
| q | Removing and installing poly V-belt → Chapter. |
| 3 - | 8 Nm |
| 4 - | Seal |
| q | PTFE oil seal: |
| q | Identification: without inner circular spring |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Renew → Chapter. |
| 5 - | Sealing flange |
| q | Coat sealing surfaces with sealant AMV 176 501 |
| 6 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter. |
| q | Dismantling and assembling pistons and conrods → Chapter. |
| 7 - | Sealing flange |
| q | Coat sealing surfaces with sealant AMV 176 501 |
| 8 - | Seal |
| q | PTFE oil seal: |
| q | Identification: without inner circular spring |
| q | Do not additionally oil or grease the oil seal sealing lip. |
| q | Before installing, remove oil residue from crankshaft journal using a clean cloth. |
| q | Renewing seal → Chapter |
| 9 - | 60 Nm + 1/4 turn (90°) further |
| q | Renew |
| q | Use counterhold tool -T10069- to loosen and tighten. |
| 10 - | Dual mass flywheel/drive plate |
| q | Removing and installing drive plate → Chapter. |
| 11 - | 23 Nm |