volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Renewing oil seal for selector shaft > < Removing and installing vehicle speed sender G68 and speed sender for intermediate shaft G265

Golf Mk4

Removing and installing gearbox oil temperature senderG93 with wiring harness
Removing and installing gearbox oil temperature sender -G93- with wiring harness
Gearbox oil temperature sender -G93- cannot be separated from the wiring harness.
Removing
–  Remove valve body → Chapter.
–  Unbolt torque converter housing → Chapter.
–  Remove bearing and differential cage.
–  Remove ATF strainer.
   
–  Pull connectors off senders -1- and -2-.
–  Unbolt retainer -4--arrow-.
–  Unbolt gearbox oil temperature sender -G93--3-.
–  Turn gearbox.
–  Unbolt cover → Chapter.
  N38-10054
Do not turn back gearbox before cover is reinstalled. Otherwise, clutch “K2/K3” and other components will fall out.
Pull connector off gearbox input speed sender -G182--1-.
  N37-10234
–  Unbolt sender and remove.
–  Remove gearbox oil temperature sender -G93- with wiring harness downwards.
Installing
–  Guide wire for sender gearbox input speed sender -G182- from beneath through gearbox housing.
  N37-10269
–  Push connector onto sender and install sender. Tighten bolt to 8 Nm.
–  Install cover → Anchor.
–  Turn gearbox.
–  Install gearbox oil temperature sender -G93- and tighten bolts to 8 Nm.
–  Push on connectors for vehicle speed sender -G68- and intermediate shaft speed sender -G265-.
–  Install wiring harness retainer and tighten bolt to 8 Nm.
–  Guide wiring into valve body housing.
–  Install ATF strainer.
Install remaining parts → Chapter.
  N37-10269

Renewing oil seal for selector shaft > < Removing and installing vehicle speed sender G68 and speed sender for intermediate shaft G265