Golf Mk4
| Removing and installing input shaft, output shaft, differential and selector forks |
| 1 - | Differential |
| q | Dismantling and assembling → Chapter |
| 2 - | Seal |
| q | Qty. 4 |
| q | Always renew |
| 3 - | Output shaft |
| q | Dismantling and assembling → Chapter |
| q | Adjusting → Chapter |
| 4 - | Reverse shaft support |
| q | Dismantling and assembling → Chapter |
| 5 - | Reverse shaft |
| q | Dismantling and assembling → Chapter |
| 6 - | Input shaft |
| q | Dismantling and assembling → Chapter |
| q | Adjusting → Chapter |
| 7 - | Selector fork for reverse gear |
| q | Dismantling and assembling → Chapter |
| q | Installation position → Anchor |
| 8 - | Bolt, 25 Nm |
| 9 - | Selector mechanism |
| q | (Selector forks) |
| q | Dismantling and assembling → Chapter |
| 10 - | Clutch housing |
| q | Repairing → Chapter |
| 11 - | Hexagon nut, 25 Nm and then turn 90° further |
| q | 4 nuts for bearing support |
