Volkswagen Workshop Service and Repair Manuals > Golf Mk4 > Power transmission | 6-speed manual gearbox 02M, 02Y, all-wheel drive | Gearbox mechanics,operation, construction,diff. | Removing and installing bevel box | Removing and installing bevel box (vehicles with 4-cylinder engine)

Torque settings

Bevel box to manual gearbox; always renew bolts

40 Nm + 45°

Flexible joint with heat shield to bevel box flange

Installing bevel box/engine carrier free of tension

–	If present, install turbocharger bracket → Rep. gr.21.

Vehicles through 09.00

When installing bevel box carrier, observe following sequence:

–	Screw in all bolts hand-tight.

–	Tighten bolts -B- and -C- first to 10 Nm.

–	Tighten bolts -A- to 45 Nm.

–	Tighten bolts -B- and -C- to 40 Nm.

Vehicles from 10.00

When installing bevel box carrier, observe following sequence:

–	Screw in all bolts hand-tight.

–	Tighten bolts -B- (M10 x 22) and bolt -C- (M8 x 22) first to 10 Nm.

–	Tighten bolts -A- (M10 x 45) to 50 Nm.

–	Tighten bolts -B- to 40 Nm.

–	Tighten bolt -C- to 25 Nm.